V3 CPE versus OTHER RADIO

[Premier]

I have several subscribers whom can see the access point at -78 to -81db. This is causing great problems with packet loss, dropped connections, slow bandwidth but to name a few. We are using various brands of radios for this.
I was going to flash a wrap board with the V3 CPE software and load it into a rootenna along with a cm9 card. Can anyone whom uses this configuration the whole time tell me how they fire out with signals in the -78 to -81 range. TIA

[tog]

Works fine for me at those signal levels so long as they are on one of my 11mbit access points. The CPE and the AP both get forced to 11mbit transmit rate for maximum stability.

Sometimes those signal levels will work at 12 or 18mbit in 2x cloaking, too.