Problems with fw 1.0.6 and how to upgrade bootrom?

[ZdenekJaburek]

Upgrading fw from 1.0.4 to 1.0.6 on WAR4 make the problem - WAR repeatedly restarted (~20sec). I reset to factory setting through serial port and all looks ok - is this ordinary situation? In package with fw 1.0.6 is
new version of bootrom. How to upload this into WAR board. I look into apConfig (version 1.5) but don't found how is possible.

Regards

Z.J.

[lonnie]

Once you have the main firmware upgraded then just upload the new bootrom. The new system can tell the difference and can even extract the version.

There have been a number of reports of this behaviour and what seems to set it off is that the scan for best channel is selected. This can actually cause a scan through DFS enabled bands and they reboot if they detect certain types of noise. Uncheck that feature before upgrading.

[ZdenekJaburek]

Ok, and how to flash new version of bootrom sw.

Thanks

Z.J.

[lonnie]

The same way you did the firmware. The system can tell the difference and to the appropriate thing.