Route problem

[anne1]

We have added 2 new boxes to our network, these boxes are Running Rip as is the rest of the network. Once we activate changes evrything works, the route table has about 25 routes.

After about 5 mins the route table changes to about 10 routes and that part of the network stops and if I activate changes again it all starts working again.

Anyone think you might know whats up?

Anne Marie

[anne1]

We think we have it sorted, added the following in the RIP config:-

ripd(config-router)# network eth0
ripd(config-router)# network wpci0


It's working, dont know if its right but it is running.