tony
01-24-2003, 06:41 PM
NOTE: This release requires the StarOS Firmware upgrade utility (starutil) version 1.4 or newer.
Updates since 1.10.4:
New: Addition of a new Router SBC Edition. (com1 console interface)
New: New routing protocols:
* RIPv1/2 (CPE Editions)
* RIPv1/2, OSPFv2 and BGPv4/4+ (Router & Server Editions)
Fixed: Some people found that the eCoinBox HotSpotzz would deactivate itself after a few days of operating, and would need the service restarted.
Updated: NAT updates to include better support for Netmeeting video & chat protocols.
** For those who try the new routing code, please report your success, failures or problems. **
-------------
NOTE to PCI Tulip card users: The Ethernet card ordering has been changed since version 1.10.1 in that the Tulip-based PCI cards are now detected LAST. Please review your setup before performing an upgrade as your cables may need to be switched around if you use this type of card.
NOTE to Intersil Prism 2.5 card users: To operate as an Access Point, or use the new volatile firmware update feature, your card must have primary firmware v1.0.7 or higher. To check and see what version your card uses, you can look in the Kernel message log. Prism 2, and other brands of cards do not have this requirement. To solve this problem, simply obtain a Windows firmware upgrade utility from the card manufacturer. (The firmware utility will upgrade both the primary and secondary firmware on your card)
Updates since 1.10.4:
New: Addition of a new Router SBC Edition. (com1 console interface)
New: New routing protocols:
* RIPv1/2 (CPE Editions)
* RIPv1/2, OSPFv2 and BGPv4/4+ (Router & Server Editions)
Fixed: Some people found that the eCoinBox HotSpotzz would deactivate itself after a few days of operating, and would need the service restarted.
Updated: NAT updates to include better support for Netmeeting video & chat protocols.
** For those who try the new routing code, please report your success, failures or problems. **
-------------
NOTE to PCI Tulip card users: The Ethernet card ordering has been changed since version 1.10.1 in that the Tulip-based PCI cards are now detected LAST. Please review your setup before performing an upgrade as your cables may need to be switched around if you use this type of card.
NOTE to Intersil Prism 2.5 card users: To operate as an Access Point, or use the new volatile firmware update feature, your card must have primary firmware v1.0.7 or higher. To check and see what version your card uses, you can look in the Kernel message log. Prism 2, and other brands of cards do not have this requirement. To solve this problem, simply obtain a Windows firmware upgrade utility from the card manufacturer. (The firmware utility will upgrade both the primary and secondary firmware on your card)