tony
12-19-2002, 04:30 PM
Updates since 1.10.4rc1:
New: Support for PLX PCI adapters in all StarOS Editions. Due to the various kinds available, we are unable to test them all. Please provide us with feedback as it will help during it's development.
* Tested: Eumitcom WL11000P (Rev A1 / 5.0v) - (WL2400 only).
* Tested: Eumitcom WL11000P (Rev 2A / 3.3v) - (11Mbit cards only).
New: Remote syslog support for all Editions.
New: 'Activate Script Changes' menu item is now functional, and allows you to [re]activate your scripts without the need to rebuild the entire network layer in the process, which can take a few seconds on some systems. Make sure you do not forget to Save your changes to disk via 'File->Save Changes'.
Updated: Updated the SSH Server and should now log in faster and not have such a long delay if it is unable to do a DNS lookup on your login IP.
Updated: Edit and status windows are now automatically full-screened when open.
Updated: Several updates to the way the card status is shown on the main screen. It now shows according to how the card is actually operating and not how it is set in the configuration.
-------------
NOTE to PCI Tulip card users: The Ethernet card ordering has been changed since version 1.10.1 in that the Tulip-based PCI cards are now detected LAST. Please review your setup before performing an upgrade as your cables may need to be switched around if you use this type of card.
NOTE to Intersil Prism 2.5 card users: To operate as an Access Point, or use the new volatile firmware update feature, your card must have primary firmware v1.0.7 or higher. To check and see what version your card uses, you can look in the Kernel message log. Prism 2, and other brands of cards do not have this requirement. To solve this problem, simply obtain a Windows firmware upgrade utility from the card manufacturer. (The firmware utility will upgrade both the primary and secondary firmware on your card)
New: Support for PLX PCI adapters in all StarOS Editions. Due to the various kinds available, we are unable to test them all. Please provide us with feedback as it will help during it's development.
* Tested: Eumitcom WL11000P (Rev A1 / 5.0v) - (WL2400 only).
* Tested: Eumitcom WL11000P (Rev 2A / 3.3v) - (11Mbit cards only).
New: Remote syslog support for all Editions.
New: 'Activate Script Changes' menu item is now functional, and allows you to [re]activate your scripts without the need to rebuild the entire network layer in the process, which can take a few seconds on some systems. Make sure you do not forget to Save your changes to disk via 'File->Save Changes'.
Updated: Updated the SSH Server and should now log in faster and not have such a long delay if it is unable to do a DNS lookup on your login IP.
Updated: Edit and status windows are now automatically full-screened when open.
Updated: Several updates to the way the card status is shown on the main screen. It now shows according to how the card is actually operating and not how it is set in the configuration.
-------------
NOTE to PCI Tulip card users: The Ethernet card ordering has been changed since version 1.10.1 in that the Tulip-based PCI cards are now detected LAST. Please review your setup before performing an upgrade as your cables may need to be switched around if you use this type of card.
NOTE to Intersil Prism 2.5 card users: To operate as an Access Point, or use the new volatile firmware update feature, your card must have primary firmware v1.0.7 or higher. To check and see what version your card uses, you can look in the Kernel message log. Prism 2, and other brands of cards do not have this requirement. To solve this problem, simply obtain a Windows firmware upgrade utility from the card manufacturer. (The firmware utility will upgrade both the primary and secondary firmware on your card)