View Full Version : Power Supply for Micro ATX
rafit
10-03-2003, 02:43 AM
Hi,
looking at the pics in your hardware section, I realize you use special power supplies; tiny and probably DC input. What are the specs and what is the source for them?
Chirpper
10-03-2003, 08:49 AM
http://www.dc2dc.com is who I use. all info should be there...
lonnie
10-03-2003, 09:08 AM
We have run out of stock. We got them from Rise Technology. The link in the posting above looks like a good source.
Also I found this one
http://www.idot.com/TheStore/Peripheral/case/Default_ps_itx.asp?Cate.id=14
georgew
10-03-2003, 11:05 AM
Does StarOS work with the VT6103 chipset ethernet controller on the VIA EPIA V, 800MHz Motherboard? 800mhz for $110, not too bad a deal. uses pc133 memoru, and has a $20 two slot pci riser available. Not a bad deal if you already have a pile of pcmcia controllers, or want to use pci radios.
Anyone have minipci to pci converters? What would be cool is a converter that was a mini pci riser with three or four mini pci slots, that plugged into the typical ITX pci slot. With that adapter board you could choose from a number of itx motherboards.
This is something cheap to manufacture, and you could combine it with commodity motherboards that are cheaper than boards you make yourself.... and you would have some flexability for future boards.
Yes, we support the VT6103 ethernet controllers.
go.fast
10-04-2003, 09:14 PM
We have run out of stock.
Are you getting more in?
lonnie
10-05-2003, 09:52 AM
The place we bought from are 2 months (as of today) back ordered. We will have the WRAP board by then so it is not worth getting them. So - No at this time we are not planning to replace them.
The links that have been posted will serve just as well as the units we had.
go.fast
10-05-2003, 07:27 PM
Does that mean you are not going to be selling the other boards like before ?
Or are you going to be selling both just without the dc to dc power supply?
George
bobbyc
10-13-2003, 12:32 PM
How much are dc-dc power supplies? Our tower company is putting in a solar repeater for a customer, and they want our power specs. I was just going to order a 733 board from valemount (since it comes with 128MB ram and DOM/license for $165), compared to a WRAP board's($120) 64MB ram and no CF card/license. Furthermore, I have a ample supply of PCMCIA to PCI adapter cards, and PCMCIA cards. If I got the WRAP board, I'd have to order 2 minipci cards.
Bob C
edit: On the idot page, should I get the Morex 60W, PW-60A 100W, or the PW70A 100MW? It's going to be a 733MW board with 2 PCMCIA to PCI adapters and 2 hermes PCMCIA cards in those adapters.
lonnie
10-13-2003, 10:07 PM
Typically I would use the 60W boards if I had fairly good and regulated 12V. If the voltage was not so nice the bigger supply has better tolerances.
bobbyc
10-13-2003, 11:18 PM
Thanks,
Bob C